B0201 | APPLICATION PAGE 2

Arcti Interior for Atriums, Cultural Interiors and Hospitality Spaces

Sculptural light that gives large indoor volumes a human scale while respecting premium finishes, circulation and the day-to-night character of the building. 

The Application Challenge

Atriums and hospitality interiors can be visually impressive but emotionally empty. Hard surfaces reflect light, ceilings may be too high for conventional decorative fixtures, and permanent chandeliers can be expensive, heavy or difficult to change when the property refreshes its identity.

The Arcti Interior Solution Approach

Suspend one large Arcti Interior composition or a carefully spaced cluster above the arrival, lounge or circulation zone. By combining soft volume, controlled brightness and a form language derived from the architecture, the installation can occupy the void without visually competing with stone, timber, glass or artwork. Tunable-white scenes can follow daylight and evening use; restrained colour can be reserved for celebrations or seasonal programming.

Recommended Design Priorities

· Architectural relationship: use geometry that responds to columns, stairs, skylights and principal sightlines.

· Daylight behaviour: evaluate the unlit object as carefully as the night effect; material colour and translucency remain visible during the day.

· Long-hour operation: design access, driver location, cleaning and replacement around the property’s maintenance team.

· Guest comfort: prevent glare into rooms, escalators, reception desks and seating areas.

· Reversibility: retain the ability to remove, re-skin or reconfigure the installation during refurbishment.

Representative Case Configuration

Illustrative case: hotel atrium “Soft Canopy”. The values below communicate scale, interfaces and customer value. They are illustrative planning values, not a completed-project claim or substitute for an approved engineering sheet.

Customer Value Delivered

· Turns unused overhead volume into a recognisable property asset.

· Supports photography, guest memory and destination identity without requiring a screen or advertisement.

· Can be refreshed through skins, colour programming or a revised cluster arrangement.

· Concentrates maintenance planning into documented access points instead of many unrelated decorative fixtures.

From Concept to Deployment

1. Confirm artistic intent, visitor relationship and the host building’s limitations.

2. Develop geometry, surface, light and inflation method as one prototype or sample package.

3. Approve rigging, access, acoustics, public interface, controls and fire documentation.

4. Produce labelled modules, drawings, cases and venue-specific installation information.

5. Inspect, operate, clean, dismantle and store according to the approved plan.

Customization Options

· Form studies matched to ceiling plans, BIM references or interior elevations.

· Warm, neutral or tunable-white diffusion; special colour only where it supports the material palette.

· DALI, 0–10 V or DMX interfaces according to selected driver and building-control strategy.

· Service package with cleaning method, spare light modules, skin replacement and access procedure.

Frequently Asked Questions

Can Arcti Interior replace the building’s general lighting?

It can contribute ambient light, but required illuminance, emergency lighting and code compliance must be provided by the building’s engineered lighting system unless a formal lighting calculation establishes otherwise.

How is fan noise handled in a quiet lobby?

Geometry may permit closed-air construction. Where continuous air is required, blowers can be remotely located, acoustically isolated and selected for the duty point.

Can the installation remain for several years?

Potentially, with approved materials, duty cycle, cleaning access and service plan. A long-term installation requires different engineering and documentation from a short exhibition.